| 專著名稱: | China Satellite Navigation Conference (CSNC) 2012 Proceedings |
| 研究中心: | |
| 首席研究員: | |
| 主編單位: | China Satellite Navigation Conference (CSNC) 2012 Proceedings |
| 出版時間: | 2012-05-16 |
| 出版社: | Springer-Verlag Berlin Heidelberg |
| 主編: | |
| 編寫人員: | 巴曉輝 |
| 總字?jǐn)?shù): | |
| 編者字?jǐn)?shù): | |
| 著作性質: | 電子、通信與自動控制技術 |
| 編輯出版單位: | China Satellite Navigation Conference (CSNC) 2012 Proceedings |
| 出版資助單位: | |
| 再版次數: | |
| 印刷數量: | |
| 參編內容: | 應用于弱GNSS信號的牽引和跟蹤方法 |
| 著作簡介: | Usually, a GPS receiver uses the digital phase-locked loop (DPLL) or digital frequency-locked loop (DFLL) as the carrier tracking loop. The success rate of pull-in process may be low under the condition of very low signal-to-noise rate (SNR), which will affect the time to first fix (TTFF) even if the receiver can successfully acquire the weak signal. An effective algorithm based on FFT for pull-in and tracking processing of weak GNSS signal is presented, which overcomes the influence of the navigation bit transition. The algorithm realizes a lot non-coherent integration through FFT processing and every input point of FFT is the accumulation of coherent integration of 20 ms. The outputs of FFT show the frequency offset, according to which the local carrier frequency is adjusted. The experimental results show that this method can effectively improve the success rate of the pull-in process and reduce the time-consuming of the pull-in process when the GPS signal power level is as low as -155 dBm. After pull-in process, the method also can keep steady tracking under the same condition. |
| 其它備注: | 國外出版-外文 |
科研產出